Filter
Top Products
Hardware configuration 35
11
Press F6 to reset to factory defaults.
12
Select Yes to reset the defaults.
13 Press Esc until you return to the IBM ServerRAID Configuration
Utility screen.
14 Select Yes to save changes made.
15
Press Esc to exit ServeRAID setup.
16
Select Yes to save the changes and exit.
--End--
Configuring the RSA-II card
Use this procedure to configure nonsecure access for the RSA-II card.
Prerequisites
• The planar and ServeRAID BIOS have both been reset to the factory
default settings.
• This procedure describes only the nonsecure configuration of the
RSA-II card. For more information about configuring security for the
RSA-II card, see Nortel AS 5300 Security (NN42040-601).
Procedure Steps
Step Action
1
From the physical KVM console, reboot the AS 5300 server and
press F1 to access the planar BIOS configuration utility.
2 From the planar BIOS setup utility screen, select Advanced
Setup.
3 Select RSA-II Settings.
4 Highlight DHCP Control and use the left and right arrow keys
to select Use Static IP.
5 Highlight Static IP Address.
6 Press the backspace key until the IP address field is empty, and
type the IP address of the RSA-II card. Use backspace key to
correct any data entry errors.
7 Highlight Subnet Mask and enter the subnet mask of the
Ethernet interface of the RSA-II card (using the same method
as for entering the IP address).
8 Highlight Gateway and enter the default gateway of the Ethernet
interface of the RSA-II card (using same method as for entering
the IP address).
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.