Filter
Top Products
UsetheOcéTDS600toprint 25
▼
▼▼
▼
Switch the Océ TDS600 printer on
1
Set the on/off switch at the rear of the printer to position ‘1’, (see figure 2). The
green LED will be on.
2
The message ’Ready to print’ appears.
▼
▼▼
▼
Switch the Océ Power Logic controller on
1
Press the on/off button on the controller, (see figure 3).
2
Press the on/off button on the monitor
The controller starts up.
Switch the Océ TDS600 printer off
▼
▼▼
▼
Switch the Océ TDS600 printer off
Note:
Ensure that the engine does not run.
1 Set the on/off switch at the rear of the printer to position ‘0’.
▼
▼▼
▼
Switch the Océ Power Logic controller off
1
Select the ‘Shut down’ option from the Océ System Control Panel.
2 Switch off the controller and the monitor (see figure 3).
Note:
Wait at least 5 seconds before you restart the Océ TDS600.