Filter
Top Products
272 Océ TDS600 Multifunctional Digital System User Manual
Note:
If the material cannot be removed easily, you must open the cover of
the fusing section to get access to the jammed material. Otherwise, the
OPC drum may become damaged.
3 Close the manual feeder again.
Paper jam in the fuser section
The fusing section is indicated as section D (see figure 163 on page 270).
Caution:
During normal use the fuser must be closed. Only open it to
remove paper after a media jam. Because of hot surfaces the operator
always has to be cautious and wear heat-protective gloves, when removing
printing material in the fuser section.
▼
▼▼
▼
How to clear a jam in the fuser section
1
Switch off the printer.
2 Wait a few moments to let the fuser cool down.
3 Open the manual feeder to release the printing material.
Attention:
If you fail to do so, the OPC drum might get damaged when you
remove jammed material.
4
Openthecoverontheleftside(seefigure166).
Note:
During normal use the left cover has to be closed. This is necessary to
ensure proper operation.
[166] Opening the left side cover