Filter
Top Products
36
|
Handbook
MCF. (Single-Loc)
Speed Access no. 70
Set ON, a MCF will be printed out automatically for single
location transmissions. When set to OFF, no report will be
printed out.
MCF. (Multi-Loc)
Speed Access no. 71
Set to ON, single and multiple location transmission
MCF99999999 will be printed automatically. When set to
OFF, no report will be printed out.
Image in MCF.
Speed Access no. 72
Set to ON, a portion of the first page of the fax transmitted
will be printed in the MCF. When set to OFF, no image will
be printed in the report.
Err. Report (MCF.)
Speed Access no. 73
Set to ON, an error report is automatically printed if a fax
communication does not end with the service code 0000.
When set to OFF, the report is not printed out automatically.
Connecting to a PBX
Private Branch Exchanges (PBXs) are private telephone
systems used to route calls internally, for example, in a
company. When dialing a telephone number, if a prefix
(access) number is required to open an outside line, the line is
connected to a PBX. If this machine is going to be connected
to a PBX, please make the following changes to enable the
machine to recognize the prefix digits in the telephone
numbers used to obtain access to the outside line. After
dialing the prefix digits, the machine will wait until the
outside line is available before dialing the rest of the number.
!
Service assistance may be required to make changes in
some countries. Also, some PBX systems may require
additional adjustments to the machine. If there is any
problem with fax communications after changing
parameters, please contact the nearest dealership for
assistance.
To Set PBX Parameters
1 Press Menu/Exit to enter Menu.
2 Input speed access no. 50 (PBX Line), wait.
3 Press ᮡ or ᮢ to select ON or OFF setting, press Enter.
4 Press ᮢ to select Dial Prefix, press Enter*.