Filter
Top Products
Handbook
|
67
function settings to adjust machine operations to best fit the
situation. During the programming sequence, the new default
combination will be indicated on the control panel
Memory Full Save
Speed access no. 17
With features like group dialing, dialing starts after an entire
document or set of documents is read into memory. If during
this process, memory becomes full and an operator time out
seems likely, a message to that effect is shown on the display
if this function is set to ON. If it is set to OFF, data not read
into memory is deleted automatically. Available settings are
ON and OFF.
Instant Dial
Speed access no. 18
In the ON state, the document is scanned into memory and
dialing starts immediately. Although the function relies on
memory availability, connection to the remote location is
confirmed and the document transmitted faster when memory
is available. If it is set to OFF, the machine first confirms
contact with the remote location and then transmits the
document reading from the document tray (without scanning
into memory).
Restrict Access
Speed access no.19
This function controls whether or not machine operation is
restricted or not. In the ON state, if restriction IDs have been
programmed, users must enter a password before being
allowed access to the machine’s functions. Set to OFF, no
password is required even if restriction IDs have been
programmed.
ECM Function
Speed access no. 20
The error correction mode (ECM) function is provided to
improve communications in areas where telephone line
conditions are very poor. Available settings are ON and OFF.
Sender ID Switch
Speed access no. 23
This function determines if the Sender ID is to be printed on
the transmitted fax. Available settings are ON and OFF: set to
ON, the ID is included on the fax.
!
In the United States, FCC regulation states that fax
machines must identify the sender and the telephone
number of the sender on each page of every fax sent.