Filter
Top Products
Microline 8480FB User’s Guide
Control Panel • 12
+
LOAD.jpg
SHIFT.jpg
Press and hold both the LOAD and the SHIFT
switches to change the printhead gap setting. The
factory default is Auto Gap in which the required
printhead gap is sensed automatically by the
printer. Use these switches to change the setting to
a manual head gap setting if you are not getting
good print results with AutoGap. See “Gap Control”
on page 44 for more information.
Control Panel Lights
Light On Off
Blinking
a
POWER Printer is turned
on.
Printer is turned
off.
N.A.
AUTO GAP Auto Gap mode is
selected (the
default).
A Manual Gap
setting is engaged.
Manual Gap setting
alarm.
ALARM • Paper is out.
• A paper jam has
occurred.
See
“Troubleshooting”
on page 69 for
more information
Printer operation is
normal.
• Awaiting removal of
single sheet/form.
• Media switch is
taking place.
• If both the ALARM
and SEL lights are
blinking, the cover
is open.
• If both the ALARM
and AUTO ALIGN
lights are blinking,
there is an
unrecoverable
error. Try turning
the printer off, then
on again. IF this
doesn‘t clear the
problem call your
service dealer
Combined Switches
With the Printer Powered Up and Off Line
Switches Task Performed