Filter
Top Products
Microline 8480FB User’s Guide
• 46
Graphics
The default is Bi-directional. Changing to Uni-directional will
improve the print registration, but slow the print speed.
High Skip
The default is Yes. This enables the low-vibration mode, which
reduces printer vibration during printing. To switch low-vibration
mode off, change this setting to No.
Hi-Impact Copy
The default is Invalid. Change the setting to Valid if you wish the
printer to automatically start up in the Hi-Impact mode when it is
turned on. The Valid setting will not engage the Hi-Impact mode
when the I-Prime (parallel) or Soft_Reset (USB) commands are
received.
Host Interface
Choose the interface mode: Auto Interface [the default], Parallel,
or USB.
I-Prime
The default is Enable: print out the buffer contents when the
I-Prime signal is received. Change to Disable if you wish the
printer to ignore the I-Prime signal.
I/F Time Out
Appears only if Host Interface is set to Auto Interface [the
default].
Choose the amount of time the printer waits (while receiving data)
before going into idle mode: 15 sec [the default], 30 sec, 45 sec, 1
min, 2 min, 3 min, 4 min, or 5 min.
If your software spends a long time processing between portions
of data it feeds to the printer, choose a longer time interval value
to keep your printer from dumping the received data while it is
waiting for more.