Filter
Top Products
Microline 8480FB User’s Guide
• 43
Auto Eject Pos.
This sets when the paper ejects, based on the distance between
the vertical center of the characters on the last line of the page
and the bottom of the page. Choose 3.18 mm (1/8") or 6.35 mm
(1/4") [the default].
Auto Feed XT
The default is Invalid. Change it to Valid if your system uses pin 14
of the parallel interface to control automatic line feed.
Auto LF
The default is No. If you want the printer to automatically add a
line feed, select Yes.
Buzzer
The default is Enable. Change to Disable to turn off the printer’s
audible alarm.
Buzzer Volume
Choose the volume of the buzzer: Low [the default], Middle, or
High.
Character Set
Choose the Character Set: Set I [the default] or Set II.
Check Print Area
Applies to manual feed from the platform with Auto Alignment
enabled. Determines whether or not data which is outside the
normal print area specified for the page prints.
The default is Valid: data overflow does not print. This prevents
such data from printing on the platen.
Caution! If you change this setting to Invalid, data could
print directly on the platen and damage the printhead.
Code Page
Choose the Code Page character set you wish to use: USA [the
default], Canada French, Multilingual, Portugal, Norway, BRASCII,
Abicomp, Multilingual 1858, or ISO-8859=15.