Filter
Top Products
Troubleshooting • 130
Cannot configure for USB connection.
NOTE
Windows 95 and NT 4.0 do not support USB; Windows
98 upgraded from Windows 95 may not support USB.
Possible cause Remedy
USB cable does not meet
specifications.
Use USB cable to specification Ver.1.1.
Interface is disabled. Check that USB interface is set to Enable in
the menu (
USB MENU → USB → ENABLE).
Configuration procedure
was not correctly
followed or cancelled.
Configure again from the beginning.
USB cable is
disconnected or faulty.
Reconnect or try another cable.
A USB hub is being used. The printer cannot be used with a USB hub.
Connect the printer and computer directly.
The USB cable is
installed in the Ethernet
port.
Make sure the USB cable is plugged into the
black USB port (1) on the printer: