Filter
Top Products
42
OKIPOS 425S
|
(4) Contents printed
When Read is OK:
(a) Prints “Read OK.”
(b) Prints the MICR read results in HEX dump.
(“XX XX ...... XX” + ASCII: 1 line contains 8 byte information)
When Read is NG:
(a) Prints “Read NG.”
(b) Prints the MICR read results (Return Code (1 byte) and read data) in HEX dump.
(“XX XX ...... XX” + ASCII: 1 line contains 8 byte information)
• Regarding MICR Read result, Return Code (1 byte) and Read Data are printed.
When the Return Code is 30H (“No errors”), it is assumed as “Read OK.” Otherwise, it is assumed as “Read NG.”
• Return codes are shown below:
Return code Status
30H (0) No errors.
33H (3) Error: Read/Decode error.
34H (4) Error: No magnetic ink detected.
36H (6) Error: Document jam or document is too long.
• When character set is CMC-7, the below codes are returned.
A25010a.doc and OP425_01.tif
A: dash symbol
B: amount symbol
C: transit symbol
D: On-Us symbol
E: comma symbol
A25010.doc
Character Code Character Code Character Code Character Code
131H232H333H434H
535H636H737H838H
9 39H 0 30H (space) 20H A 41H
B 42H C 43H D 44H E 45H
• When character set is E-13B, the below codes are returned.
A25011a.doc and OP425_02.tif
A: dash symbol
B: amount symbol
C: transit symbol
D: On-Us symbol
A25011.doc
Character Code Character Code Character Code Character Code
131H232H333H434H
535H636H737H838H
9 39H 0 30H (space) 20H - -
A 41H B 42H C 43H D 44H
Note In both cases of CMC-7 and E-13B, special character codes are different from those sent to host by a check paper
read command.