Filter
Top Products
|
Developer’s Guide: English 75
5.7.5.1.7 Provisions on Fold, Bend and Curl on Cut-sheet Paper
Paper is apt to sustain bends, cambers or curls resulting from manual handling, carrying, stacking, storing conditions, etc.
Therefore, before printing, check and adjust paper in accordance with the provisions below to eliminate paper feed problems.
Do not use paper that does not meet the specifications outlined here: it may cause paper feed problems. Problems caused by
using non-specified paper are not covered under warranty.
1) Fold
(a) Do not use a sheet which is folded across its width (A). Even if such paper is smoothed, its strength is still uneven.
(b) For paper with a folded corner (B), if the fold height after adjustment is 2 mm or less, it may be used for printing.
OP425_17.eps
1 15mm or more
2 Adjusted to make the height 2mm or less
2) Bend and Curl
(a) If a sheet has a curl height of 2 mm or less (A), it may be used for manual feed printing.
(b) If a sheet has a bending height of 2 mm or more within 15 mm from the bending line (B), do not use it for printing.
OP425_18.eps
1 Circular arc
2 2mm or less
3 Adjusted to make the height 2mm or less
4 15mm or more
1
2
A
B
1
2
3
4
A
B