Filter
Top Products
48
OKIPOS 425S
|
3. Remove the paper roll on the rewinder, following the procedure below.
(1) Remove the rewinder (1) from the printer (2).
o425_37.jpg
(2) Rotate the flange (2) in the direction shown below and remove it from the rewinder (1).
Note 1: Rotation direction of the flange varies depending on the width of the Roll Paper.
Arrow 3: Wide Roll Paper (Width: 76.2 mm)
Arrow 4: Narrow Roll Paper (Width: 69.5 mm)
Note 2: When a spacer is installed, remove the spacer along with the flange.
o425_44.jpg
(3) Pull the Roll Paper (1) out from the rewinder (2). When it is tight, rotate the rewinder in the direction below, and pull
out the paper.
o425_45.jpg
4. Load new paper roll.
For loading Roll Paper, refer to Section 1.5.1.2.
1
2
1
2
2
4
1
3