Filter
Top Products
21
Operating the MAUSB-10
The operating procedures for the MAUSB-10 under Windows 2000/XP are described below.
1 Connecting to the computer <2000/XP
ࡗ
Operation>
After installing the device driver, connect the MAUSB-10’s connector to the USB port on your computer. (You
can plug in the USB connector while the computer is in use.)
[Notes]
• Be sure to connect the MAUSB-10 to your computer AFTER installing the device driver.
• Make sure the connector is fully inserted.
• When inserting the connector, make sure it is oriented correctly (refer to the pictures below). Inserting the
connector incorrectly may damage the connector and/or the computer’s USB port.
USB port
(Type A)
The computer’s
USB port has a
mark over it.
Installing the new hardware
The first time the MAUSB-10 is connected to your computer, the “Found New Hardware Wizard” window
appears.
Log on with the user name “Administrator”, or use a user name with administrator privileges, then follow the
steps under [Installing the hardware] on the next page. Once the driver is installed, you only need to perform
step 6 on the next page.
[For Windows 2000]
If you do not log on with the user name
“Administrator”, or if you do not use a user name
with administrator privileges, the window at right
appears and you cannot install the driver. Check
the administrator’s name and password, then log
on again.
[For Windows XP]
If you do not log on with the user name
“Administrator”, or if you do not use a user name
with administrator privileges, the window at right
appears. Enter the correct user name and pass-
word then click “OK”.