Filter
Top Products
-24-
$
$$
$
MODE
This can be set to either “AD HOC”
or “INFRASTRUCTURE”. If using
methods (1) or (2) as described on
page 15 of “Wireless function
preparation”, set to “AD HOC”. If
using method (3) in “Wireless
function preparation”, set to
“INFRASTRUCTURE”.
Use the I or H button to change
the setting, and then press the
ENTER button.
SETUP
MODE
AD HOC
INFRASTRUCTURE
Some of the settings used differ between AD HOC mode and
INFRASTRUCTURE mode.
AD HOC
INFRASTRUCTURE
%
%%
%
Channel
This lets you set the channel. You must set the channel to the
same channel that is being used by the wireless card of the
transmitting computer.
In INFRASTRUCTURE mode, operation is usually possible
regardless of the settings used. However, for some access points,
you may need to set the channel to the same channel that is used
by the access point, otherwise communication may not be possible.
Use the I or H button to change the setting, and then press the
ENTER button.
SETUP
CH
11
Note:
• The channels that can be used will vary depending on the
country (page 6).