Filter
Top Products
Remote control operation
32 -
ENGLISH
Basic Operation
Loading a saved setting
Displays the [MEMORY LOAD] menu.
Press
Attention
Setting can also be performed using the on-screen menu.
z
For details, see [MEMORY LOAD] in the [PICTURE]
menu. (
page 54)
Displaying the [VIERA LINK]
menu
You can control some functions of the external device
with this projector remote control.
Press
Note
See “Using VIERA Link” for details. (
z
page 82)
Displaying the waveform
monitor
By displaying the input signal from a connected
external device with a waveform, you can check if the
video signal (luminance) level is set to a value within
this projector’s recommended range, and can adjust it
accordingly.
Press
The settings change as follows each time the
<ENTER> button is pressed.
[FULL SCAN (Y)] [FULL SCAN (R)]
[SINGLE LINE SCAN (B)] [FULL SCAN (G)]
[SINGLE LINE SCAN (G)] [FULL SCAN (B)]
[SINGLE LINE SCAN (R)] [SINGLE LINE SCAN (Y)]
The waveform monitor disappears when the
<WAVEFORM MONITOR> button is pressed again.
Note
Setting can also be performed using the on-screen menu.
z
For details, see [WAVEFORM MONITOR] in [PICTURE]
menu. (
page 39)
[FULL
SCAN]
Checks that the waveform for each of the
Y- (brightness), R- (red), G- (green), and
B- (blue) values for the whole image is
within the recommended range.
[SINGLE
LINE
SCAN]
Checks that the waveform for each of the
Y- (brightness), R- (red), G- (green), and
B- (blue) values for an arbitrary number
of lines from the top of the screen to the
bottom is within the recommended range.
Enables more detailed conrmation than
z
[FULL SCAN].
Line position can be changed with the ▲▼
z
buttons.
The display position of the [WAVEFORM
z
MONITOR] changes depending on the line
position.
Note
Signals lower than 0 % in the waveform monitor will be
z
displayed as same as 0 % on the projected image.
[SINGLE LINE SCAN] can display horizontal lines in Y-
z
(brightness), R- (red), G- (green), and B- (blue) from the
top of the screen to the bottom more nely than [FULL
SCAN], and each item can be adjusted in the same way
as [FULL SCAN].
When selecting [FULL SCAN], the display position of the
z
waveform can be set using the ▲▼
▲
▼
buttons.
So that the display of individual adjustment screen in
z
[PICTURE] does not interfere with the waveform monitor,
the positioning of this screen differs depending on the
circumstances at the time.
The [AUTO ADJUST] is executed by pressing the
z
<DEFAULT> button while the waveform is displayed.
(
page 39)
While the waveform monitor is displayed, you cannot
z
adjust the [COLOR MANAGEMENT] settings.
Resetting to the default
settings
You can reset most of the settings or adjustment
values for submenus to factory default settings.
Press
For details, see “Navigating through the menu -
Returning adjusted values to default settings” of “Menu
navigation”. (
page
34)