Filter
Top Products
[POSITION] menu
58 -
ENGLISH
Settings
[WSS]
In the European broadcasting system, if the input
signal contains an identication signal, WSS
automatically switches the aspect ratio to the required
setting. (
page
56)
Switch settings Switch settings
[ON] Switch automatically
[OFF] Do not switch automatically
Note
Aspect ratio switches only in the case of these input
z
signals: PAL/625i (576i)/625p (576p)
[OVER SCAN]
If the 4 edges of an image are partly dropped, you can
use this function to adjust and project it properly.
Shrink image
Enlarge image
Setting range: 0 to +10
z
Note
COMPUTER signal (exc. movie based signals) is not
z
supported.
[KEYSTONE]
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can correct the keystone vertically.
Image Operation
Setting range: −32 to +32
z
Note
You can correct the distortion ± 30 degrees from the
z
vertical plane. However, if there is overcorrection, the
image quality may deteriorate and become blurry. For a
better quality image, installing the projector with minimum
distortion is recommended.
The result of the keystone correction will affect the size of
z
the image.
Keystone correction does not function on the menu
z
screen.
When adjustment with [KEYSTONE] carried out, the
z
vertical center of the screen and the lens need to be
realigned.
Some distortion may occur due to lens shift adjustment.
z
The result of the keystone correction may affect the
z
aspect ratio.
[AUTO SETUP]
(COMPUTER IN only)
When you select [AUTO SETUP] and then press the
<ENTER> button, [H-POSITION], [V-POSITION],
[DOT CLOCK], and [CLOCK PHASE] are adjusted
automatically in accordance with the input signal.