Filter
Top Products
About your projector
ENGLISH - 19
Preparation
About your projector
Remote control
■
Top
(1) Remote control indicator
Flashes if any button in the remote control is pressed.
(2)
Power standby <
> button
Sets the projector to the standby mode when the <MAIN POWER> switch on the
projector is set to <ON>.
(3)
Power on <
> button
Starts projection when the <MAIN POWER> switch on the projector is set to <ON>
when the power is switched off (standby mode).
(4) Input selection (<RGB1>, <RGB2>, <DVI-D>, <VIDEO>, <S-VIDEO>, <HDMI>)
buttons
Switches the input signal to project.(
page 41)
(5) <MENU> button/<ENTER> button/
buttons
Used to operate the menu screen.(
page 44)
(6) <ON SCREEN> button
Switches the on-screen display function on (displayed)/off (hidden).(
page 41)
(7) <TEST PATTERN> button
Displays the test pattern.(
page 42)
(8) Number (<0> - <9>) buttons
Used when the system uses multiple projectors.
Used to input ID numbers or passwords.
(9) <STATUS> button
Displays the projector information.
(10)<AUTO SETUP> button
Automatically adjusts the image display position while projecting the image.
[PROGRESS] is displayed on the screen while the image is adjusted automatically.
(
page 42)
(11) <SHUTTER> button
Use to temporarily turn off the image.(
page 41)
(12)<ASPECT> button
Switches the aspect ratio of the image.(
page 43)
(13)Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the projection lens. (
pages 37, 39)
(14)<FUNCTION> button
You can assign a frequently used operation as a shortcut button.(
page 42)
(15)<DEFAULT> button
Resets the content of the sub-menu to the factory default.(
page 44)
(16)<ID SET> button
Sets the ID number of the remote control to use for a system using multiple
projectors.(
page 22)
(17)<ID ALL> button
Use to simultaneously control all the projectors with one remote control for a system
using multiple projectors.(
page 22)
Attention
z
Do not drop the remote control.
z
Avoid contact with liquids or moisture.
z
Do not attempt to modify or disassemble the remote control.
Note
z
The remote control can be used within a distance of about 30 m (98'5")
if pointed directly at the remote control receiver. The remote control can
control at angles of up to ±15° vertically and ±30° horizontally, but the
effective control range may be reduced.
z
If there are any obstacles between the remote control and the remote
control signal receiver, the remote control may not operate properly.
z
The signal will be reected off the screen. However, the operating range
may be limited from light reection loss due to the screen material.
z
If the remote control signal receiver directly receives strong light, such as
uorescent light, the remote control may not operate properly. Use it in a
place distant from the light source.
z
The power indicator <ON (G)/STANDBY (R)> will ash if the projector
receives a remote control signal.
Remote control signal transmitter
■
Front
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
■
Bottom
Remote control wired terminal
(
page 22)