Filter
Top Products
[NETWORK] menu
88 - ENGLISH
Settings
■
Error information page
When [Error (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to
display the error details.
z
The projector may go into the standby status to protect the projector depending on the contents of the error.
[OK]: operating properly
[FAILED]: a problem occurred
[WARNING]: warning
z
Description of problem occurrence [FAILED]:
Parameter Description
[MAIN CPU BUS]
There is a problem with the microcomputer circuitry. Consult your
dealer.
[FAN]
There is a problem with the fan or the fan drive circuit. Consult your
dealer.
[INTAKE AIR TEMPERATURE]
The air intake temperature is too high. It may be used in an operating
environment where the temperature is high, such as near a heating
appliance.
[OPTICS MODULE TEMPERATURE]
The temperature inside the projector is high. It may be used in an
operating environment where the temperature is high, such as near a
heating appliance.
[AROUND LAMP TEMPERATURE]
The temperature around the lamp is high. The air exhaust port may
be blocked.
[LAMP1 REMAIN TIME]
The usage time of the lamp has exceeded the specied time, and it is
time to replace the lamp.
[LAMP2 REMAIN TIME]
[LAMP1 STATUS]
The lamp has failed to turn on. Wait a while until the luminous lamp
cools off, and then turn on the power.
[LAMP2 STATUS]
[SHUTTER] There is a problem with the shutter circuitry. Consult your dealer.
[INTAKE AIR TEMP.SENSOR]
There is a problem with the sensor used to detect intake air
temperature. Consult your dealer.
[OPTICS MODULE TEMP.SENSOR]
There is a problem with the sensor used to detect temperature inside
the projector. Consult your dealer.
[AROUND LAMP TEMP.SENSOR]
There is a problem with the sensor used to detect exhaust air
temperature. Consult your dealer.
[BATTERY] Battery replacement is required. Consult your dealer.
[COLOR WHEEL]
There is a problem with the color wheel or the color wheel drive
circuit. Consult your dealer.
[COVER OPEN]
The lamp unit cover is not attached properly. Check the installation of
the lamp unit cover.(
page 107)
[FILTER UNIT]
The air lter unit is not attached. Check the connection of the air lter
unit.(
page 105)
[AIR FILTER]
There are too much dust accumulated in the air lter unit.
Turn off the <MAIN POWER> switch to <OFF>(
page 38), and clean
the air lter.(
page 104)