Filter
Top Products
[PROJECTOR SETUP] menu
70 - ENGLISH
Settings
z
To delete a command already set, press the
<DEFAULT> button on the Step 6) screen, or select
[DELETE] on the Step 7) screen and press the
<ENTER> button.
z
If multiple commands have been set for the same
time, they are executed in chronological order
starting from the smallest command number.
z
The operating time will be the local time.(
page 73)
z
If an operation is executed with the remote control
or control panel of the projector or with a control
command before the command set in [SCHEDULE]
is executed, the command set with this function
may not be executed.
[STARTUP INPUT SELECT]
Set the input signal when the power is turned on.
1) Press
to select [STARTUP INPUT
SELECT].
2) Press
to switch [STARTUP INPUT
SELECT].
z
The setting will change as follows each time
you press the button.
[LAST USED] [RGB1]
[RGB2]
[HDMI]
[VIDEO]
[DVI-D] [S-VIDEO]
[LAST USED] Keep the input selected last time.
[RGB1]
Set the input when the power is
turned on to RGB1.
[RGB2]
Set the input when the power is
turned on to RGB2.
[VIDEO]
Set the input when the power is
turned on to VIDEO.
[S-VIDEO]
Set the input when the power is
turned on to S-VIDEO.
[DVI-D]
Set the input when the power is
turned on to DVI-D.
[HDMI]
Set the input when the power is
turned on to HDMI.
[RS-232C]
Set the communication conditions of the <SERIAL
IN>/<SERIAL OUT> terminal.
1) Press
to select [RS-232C].
2) Press the <ENTER> button.
z
The [RS-232C] screen is displayed.
3) Press
to select an item.
■
To set the communication
condition of the <SERIAL IN>
terminal
4) Select [(IN) BAUDRATE] in Step 3).
5) Press
to switch [(IN) BAUDRATE].
z
The setting will change as follows each time
you press the button.
[9600] [19200] [38400]
6) Press
to select [(IN) PARITY].
7) Press
to switch [(IN) PARITY].
z
The setting will change as follows each time
you press the button.
[NONE] [EVEN] [ODD]
■
To set the communication
condition of the <SERIAL OUT>
terminal
4) Select [(OUT) BAUDRATE] in Step 3).
5) Press
to switch [(OUT)
BAUDRATE].
z
The setting will change as follows each time
you press the button.
[9600] [19200] [38400]
6) Press
to select [(OUT) PARITY].
7) Press
to switch [(OUT) PARITY].
z
The setting will change as follows each time
you press the button.
[NONE] [EVEN] [ODD]
■
To set the response
4) Select [RESPONSE(ID ALL)] in Step 3).
5) Press
to switch [RESPONSE(ID
ALL)].