Filter
Top Products
[PROJECTOR SETUP] menu
ENGLISH - 71
Settings
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Returns the response when the ID
setting is ALL.
[OFF]
Does not return the response
when the ID setting is ALL.
6) Press
to select [GROUP].
7) Press
to switch [GROUP].
z
The setting will change as follows each time
you press the button.
[A] [B] [Z]
[A] - [Z]
Controls multiple projectors
simultaneously by sending the ID of
RS-232C.
Set the group from [A] to [Z]. The
projector responds when the ID of
RS-232C matches the setting.
8) Press
to select [RESPONSE(ID
GROUP)].
9) Press
to switch [RESPONSE(ID
GROUP)].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Returns the response when the ID
setting is GROUP.
[OFF]
Does not return the response
when the ID setting is GROUP.
Note
z
Refer to “<SERIAL IN>/<SERIAL OUT> terminal”
(
page 113).
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press
to select [REMOTE2 MODE].
2) Press
to switch [REMOTE2
MODE].
z
The setting will change as follows each time
you press the button.
[DEFAULT] [USER]
[DEFAULT]
The pin assignment of the
<REMOTE 2 IN> terminal is used
by the factory default setting of the
projector.
(
page 116)
[USER]
Used to change the setting of the
<REMOTE 2 IN> terminal.
■
To set [USER]
3) Select [USER] in Step 2).
4) Press the <ENTER> button.
5) Press
to select either [PIN2] or
[PIN8] and press
to switch the
setting.