Filter
Top Products
Chapter 1 Preparation — Start-up display
ENGLISH - 25
Initial setting (standby mode)
Set the operation mode during standby. The default setting is [ECO] that keeps power consumption low during standby. When the network
function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
1) Press qw to switch the setting.
3/4
ENTER
SET
CHANGE
If STANDBY MODE is set to ECO, you cannot use
network functions when the projector is standing by.
Also, you cannot use some RS-232C protocol
commands.
STANDBY MODE
ECO
INITIAL SETTING
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The above initial setting screen is the one displayed when the projector is switched on for the rst time after purchase. When [ALL USER
DATA] in the [PROJECTOR SETUP] menu → [INITIALIZE] is executed, the setting of [STANDBY MODE] before execution is displayed.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image. After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
1) Press as to select an item.
2) Press qw to switch the setting.
16:10
4/4
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGEMENU SELECT
SCREEN FORMAT
ENTER
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Note
f If you press the <MENU> button on the initial setting screen, you can go back to the previous screen.
f To continue operations after completed the initial settings, refer to “Selecting the input signal” (x page 51).
f By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.