Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
50 - ENGLISH
Direct power off function
The projector can be turned off during projection or immediately after the luminous lamp is turned off by setting the <MAIN POWER> switch to
<OFF>. Also, when the projector is mounted on the ceiling or installed in an environment where the <MAIN POWER> switch of the projector
cannot be easily turned <OFF>, the power can be turned off directly using the circuit breaker. It is also safe in case a power outage occurs or
the power cord is pulled out immediately after the projector is switched off.
Note
f If the projector was turned off by turning off the circuit breaker directly during projection last time, then the power indicator <ON (G)/
STANDBY (R)> will light in green a while after the circuit breaker is turned on, and then projection of the image will start.
f If the power was turned off directly by turning the <MAIN POWER> switch to <OFF>, or the power was turned off by turning off the circuit
breaker directly, projection may take a longer time than usual to start when the projector is switched on the next time.