Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 47
Switching on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely xed to the projector body to prevent it from being removed easily.
Conrm that the <MAIN POWER> switch is on the <OFF> side before connecting the power cord.
For details of power cord handling, refer to “Read this rst!” (x page 2).
Attaching the power cord
1) Check the shapes of the <AC IN> terminal on the rear of the projector body and the power cord
connector, and insert the plug completely in the correct direction (until you hear the side tabs click in
place).
Removing the power cord
1) Confirm that the <MAIN POWER> switch on the rear of the projector body is on the <OFF> side, and
remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.
Power indicator
Displays the status of the power. Check the <ON (G)/STANDBY (R)> status of the power indicator before operating the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status Projector status
Off The main power is switched off.
Red Lit
The power is switched off (in standby mode).
Projection will start when the power on <b> button is pressed.
f The projector may not operate when the lamp indicator <LAMP> or temperature
indicator <TEMP> is ashing. (x page 129)
Green Lit Projecting.
Orange Lit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)