Filter
Top Products
Adjusting the lens
The projector is equipped with electronic zoom and electronic focusing mechanisms, so that you can carry out
adjustments simply by pressing the ZOOM (+/-) buttons and the FOCUS (+/-) buttons on the top of the projector, or
by following the on-screen adjustment display. Alternatively, you can adjust the focus by turning the lens directly.
NOTE:
If these buttons are pressed while the on-screen display for some other function is on the screen, the buttons
pressed will operate but the on-screen display will not switch to the ZOOM or FOCUS adjustment screen. Thus
there may be cases where the operation and the display do not match.
Adjustment procedure <for direct adjustment>
1.
Press the ZOOM (+/-) buttons on the operation panel on the top of the projector to
adjust the size of the picture.
If the “+” button is pressed, the picture becomes larger, and
if the “-” button is pressed, the picture becomes smaller.
2.
Press the FOCUS (+/-) buttons on the operation panel on the top of the projector to
adjust the focus of the picture.
Adjust so that the image projected onto the screen is at the
optimum focus.
NOTE:
If approximately five seconds pass without any buttons being pressed, the adjustment screen will be cleared.
Adjustment procedure <adjusting using the on-screen adjustment display>
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and
“ ” buttons to select “ZOOM”.
3. Press the “<” and “>” buttons to display the ZOOM adjustment screen.
4. Press the “<” and “>” buttons to adjust the picture size.
If the “+” button is pressed, the picture will become larger, and if the “-” button is
pressed, the picture will become smaller.
5.
Press the MENU button, or wait for approximately five seconds without pressing any
button. The display will then return to the MENU screen.
6. Press the “ ” and “ ” buttons to select “FOCUS”.
7. Press the “<” and “>” buttons to display the FOCUS adjustment screen.
8. Press the “<” and “>” buttons to adjust the picture focus.
Adjust so that the image projected onto the screen is at the optimum focus.
NOTE:
If approximately five seconds pass without any buttons being pressed, the display will return to the MENU screen.
The projector is equipped with a lens retracting function which will cause the lens to be retracted automatically
when the power is turned off. However, the lens will not then return to the previously adjusted position even if the
power is turned back on again. If you do not wish this function to operate, turn the function setting off while
referring to “Using the lens retracting function” on page 31.
16