Filter
Top Products
<Switching the signal mode during RGB signal input>
If the picture is not projected normally when the selected input source is “RGB 1” or “RGB 2” because the signal
mode selected does not match, select the correct signal mode by the procedure given below. The factory pre-
setting is “AUTO”, so the projector can usually be used without the need to change this setting.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and
“ ” buttons to select “PICTURE”.
3. Press the “<” and “>” buttons to display the PICTURE screen.
4. Press the “ ” and
“ ” buttons to select “SIGNAL MODE”.
5. Press the “<” and “>” buttons to switch the signal name.
Refer to the table below when switching to the matching signal mode.
Display mode name
No. of dots
Signal data
Horizontal scanning frequency (kHz) Vertical scanning frequency (Hz)
AUTO
Automatically switches to whichever of the following signal modes best matches the input signal
VGA 400
640 × 400 31.5 70.0
VGA 480
640 × 480 31.5 60.0
MAC 13
640 × 480 35.0 66.7
PC 98
640 × 400 24.8 56.4
VESA
640 × 480 37.9 72.8
S-VGA 1
800 × 600 35.2 56.3
S-VGA 2
800 × 600 37.9 60.4
S-VGA 3
800 × 600 46.9 75.0
S-VGA 4
800 × 600
48.1
72.0
S-VGA 5
800 × 600
32.1
51 .0
MAC 16
832 × 624 49.7 74.6
XGA 1
1024 × 768 48.4 60.0
XGA 2
1024×68
56.4 70.0
XGA 3
1024 × 768 68.7 85.0
MAC 19
1024 × 768 60.2 75.0
NOTE:
The display resolution for the PT-L595U projector is 800 × 600 dots. If any of the above signals which have
resolutions greater than this are input, the resolution will be converted to 800 × 600 dots.
The setting screen and the MENU screen can both be cleared by pressing the MENU button.
19