Filter
Top Products
CAUTION
When using the projector
Do not use the projector in places which are subject to humidity, dust, oil fumes or steam.
Fire or electric shocks could result.
Do not place any heavy objects on top of the projector.
Doing so can cause the projector to become unbalanced and fall, which could result in damage and/or injury.
Do not look into the lens while the projector is being used.
Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your
eyes.
Do not bring your hands or other objects close to the air outlet port.
Heated air comes out of the air outlet port. Do not bring your hands or face, or objects which cannot withstand
heat close to this port, otherwise burns or deformation could result.
When disconnecting the power cable, hold the plug, not the cable.
If the power cable itself is pulled, the cable will become damaged, resulting in the possibility of fire or serious
electric shocks.
Be sure to disconnect all cables before moving the projector.
If the projector is moved while some of the cables are still connected, the cables may become damaged, and fire
or electrical shocks could result.
Cleaning and maintenance
Take particular care when replacing the lamp unit.
The metal halide lamp contains gas under high pressure. If it is dropped or hit against other objects, it may
break, which could cause injury or problems with operation.
Ask an Authorized Service Center to clean inside the projector at least once a year.
If dust is left to build up inside the projector without being cleaned out, it can cause fire or problems with
operation to occur. Ask your nearest Authorized Service Center to clean the projector when required. Consult
your Authorized Service Center for details regarding cleaning costs.
Disconnect the power plug from the wall outlet as a safety precaution before carrying out any cleaning.
Electric shocks can result if this is not done.
Warning when using 220— 240 V power supplies
When using this projector with a 220— 240 V power supply, you
must replace the power cord and the fuse. Use a power cord and
Power cord
250 V AC, 10 A
fuse which corresponds to the specifications given at right. If this
Fuse
250 V AC, T4 A,
is not done, fire or malfunctions may result.
5.2 mm dia., 20 mm length
Replace the fuse by the following procedure.
Insert a flat-tipped screwdriver
After the fuse holder has moved Replace the fuse with a 250 V
with a narrow head into the hole forward slightly, pull it out toward AC, T4 A fuse, and then push the
below the fuse holder, and turn
you.
fuse holder securely back into
the screwdriver 2 - 3 times to the
place.
left and right.
MAIN POWER
MAIN POWER
OFF
ON
OFF
ON
AC IN
Fuse
AC IN
4