Filter
Top Products
In order to conserve power, the projector is equipped with a power save function which causes it to switch
automatically to the standby condition if no signal is input for 10 minutes or more. At the time of shipment from the
factory this function is set to “OFF”. If you would like to use the function, change the setting to “ON” by the
following procedure.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and
“ ” buttons to select “OPTION”.
Using the power save function
3. Press the “<” and “>” buttons to display the OPTION screen.
4. Press the “ ” and “ ” buttons to select “POWER SAVE”.
5. Press the “<” and “>” buttons to change the setting to “ON”.
If you change the setting to “OFF”, the power save function will be
disabled.
NOTE:
Press the MENU button to clear the setting screen and the MENU screen.
If both this function and the lens retracting function described below are set to “ON”, the lens will be
automatically retracted when the projector switches to standby mode. If this happens, you will need to readjust
the zoom and focus of the lens after starting the projector again.
Using the lens retracting function
This function causes the projector lens to be retracted automatically when the projector switches to standby mode,
and extends the lens again when the projector starts back up again. Having this function set to “ON” is useful if the
projector will not be used for an extended period of time, or when the projector is to be transported somewhere.
However, once the lens has been retracted, it will be necessary to readjust the zoom and focus of the lens once
the projector has been started up again. At the time of shipment from the factory this function is set to “ON”.
Setting procedure
1. Press the MENU button to display the MENU screen.
2. Press the “ ” and
“ ” buttons to select “OPTION”.
3. Press the “<” and “>” buttons to display the OPTION screen.
4. Press the “ ” and “ ” buttons to select “LENS RETRACT”.
5.
Press the “<” and “>” buttons to change the setting to “ON”.
If you set this function to “ON”, the lens will be extended and retracted each
time the power is turned on and off.
NOTE:
If this function is set to “OFF”, the lens will remain extended at all times.
Press the MENU button to clear the setting screen and the MENU screen.
31