Filter
Top Products
Part I Sounds and effects
42
QQTG0692
Sounds and effects
MULTI EFFECT
The MULTI EFFECT works like a studio effects
processor, providing effects such as CHORUS,
PHASER, DELAY and DISTORTION.
1.
In the CONDUCTOR or PART SELECT sec-
tion, turn on the part to which this effect will be
applied.
2.
Press the MULTI EFFECT button to turn it on.
Ⅲ
ⅢⅢ
Ⅲ
Type and parameter settings
1.
Press and hold the MULTI EFFECT button for
a few seconds.
• The display changes to the following.
2.
Use the ▲ and ▼ buttons to select an effect
group.
• The EFFECT MEMORY is for edited effects
(see below).
3.
Use the buttons to the right of the display to
select the type.
• If the types comprise more than one display
“page,” use the PAGE buttons to switch
pages.
• Press the VARI button to enable the variation
effect.
• This display can also be accessed from the
REVERB & EFFECT MENU display. (Refer to
page 155.)
Ⅲ
ⅢⅢ
Ⅲ
EFFECT EDIT
The effects can be edited and then stored in a
memory.
1.
Select an effect type to use as a base.
2.
Press the EDIT button.
• The display changes to the following.
3.
Use the PARAMETER ▲ and ▼ buttons to
select the parameter.
4.
Use the VALUE
∧
and
∨
buttons to adjust the
setting.
• The parameters vary depending on the effect
type selected as the base.
• (V) is the abbreviation of VARIATION.
5.
Press the WRITE button.
6.
Press the EFFECT NAMING button and
assign a name to the effect, if necessary.
• Refer to page 65 for details about the
NAMING procedure.
7.
Use the EFFECT MEMORY ▲ and ▼ buttons
to specify the location in which to store the
edited effect.
8.
Press the OK button.
MULTI
EFFECT
06_Part I.fm 42 ページ ２００３年２月５日 水曜日 午後２時３８分