Filter
Top Products
Part IV Sequencer
80
QQTG0692
Sequencer
CYCLE RECORD
This mode allows you to have specified record-
ing measures continuously repeated. Thus you
can record measures by adding notes during any
cycle.
1.
On the REALTIME RECORD display, specify
“REC” for a track number you are going to
record, and “PLAY” for track numbers you
wish to have played back.
2.
Press the CYCLE: OFF button.
• The display looks similar to the following.
3.
Use the START MEASURE
∧
and
∨
buttons
to specify the beginning measure number.
4.
Use the END MEASURE
∧
and
∨
buttons to
specify the ending measure number.
• The measure in which the END command has
been stored can also be specified.
5.
Press the START/STOP button.
• If the metronome is on, cycle recording of the
specified measures begins after a two-
measure count.
6.
Play the keyboard.
• The specified measures are repeated, during
which time you can record by adding notes lit-
tle by little at the correct timing (over-dubbing).
• If you wish to erase all the performance data
from the specified measures, press the
CLEAR button.
• If the CYCLE: ON button is pressed, it
changes to OFF. This button does not function
during recording.
• To return to the REALTIME RECORD display,
press the EXIT button.
• Cycle record can also be started from the
REALTIME RECORD display whenever the
CYCLE: ON indication is shown.
7.
When you have finished recording, press the
REC STOP button on the display, or turn off
the PROGRAM MENUS button.
START
CYCLE END MEASURE: 4
1234
END
09_Part IV.fm 80 ページ ２００３年２月５日 水曜日 午後１時３４分