Filter
Top Products
25
ENGLISH
Installing Your Machine
1
NOTE
1. Please observe the standards for USB cables.There is a danger that circuit board could be damage by voltage difference.
It is recommended that identical cable taps be used to supply power.
Plug one end of the Telephone
Line Cable into the telephone
jack supplied by the telephone
company and the other end into
the LINE jack on the back of
the machine.
Telephone Line Jack
(Optional G3 Communication Port Kit
(UE-407029) is required.)
Optional 2nd Telephone Line Jack
Optional Telephone Handset Jack
or ExternalTelephone Jack
Connect the Telephone Line Cable from the
Optional Handset Kit into the HANDSET
jack on the back of the machine.
You can connect an additional standard
single line telephone to the machine.
To connect a telephone,
remove the protective tab on the TEL jack.
or
RJ-11C
Telephone Jack
(Service use only)
POWER
(Some models may have
the Power Switch.)
(For Document Management
See Operating Instructions
System)
USB Port
LAN Connection Jack
(10BASE-T/100BASE-TX)
LAN Cable
(10BASE-T/100BASE-TX Cable)
Insert the plug until a click is heard.
(LAN cable is not included with the product.)
Purchase a Category 5 Cable, compliant with
EIA/TIA 568-A-5 standard.
10BASE-T/100BASE-TX Ethernet Hub
Ethernet LAN
(10BASE-T/100BASE-TX
Cable not included)
Power Cord (Included)
Handset Kit (Optional)
(UE-403185)
LINK Lamp (green)
Illuminates when connected
to the LAN.
Lamp will not turn ON if LAN
cable is defective (contains breaks).
RX Lamp (orange)
Blinks when there is data
traffic on the LAN.