Filter
Top Products
25
■ ID registration for follower units
• To talk with the headsets (Order Taker and All-in-One Headset), ID registration is required.
• For ID registration, set the center module in ID registration mode and make operation of ID registration by means of a follow-
er unit.
ID registration procedures are described below based on the All-in-One Headset.
1. Turn on the power of the Center Module.
2. Press the ID Registration Button of the center module for
2 seconds or more. The system is changed to the ID
Registration mode. The ID Registration Indicator blinks.
3. While holding down the buttons T1 and T2 simultaneous-
ly, hold down the power button to turn on All-in-One
Headset. The All-in-One Headset enters the ID
Registration setting mode where the indicators and but-
tons have different functions than in normal operation.
You will hear "ID Registration Mode" and the power indi-
cator will blink yellow.
4. Press the T1 button, the All-in-One Headset searches for
the center module. You can hear "Connecting center
module A" and the lane Indicator will blink yellow.
* Press the T2 button (at double-drive-thru), for other cen-
ter modules. You can hear "Connecting center module
B" and the lane indicator will blink green.
When the ID Registration succeeds, you will hear
"Registration Complete" and the headset number, and
the power indicator stops blinking and stays on.
5. When IDs are registered on all All-in-One Headsets,
press the ID button of the center module, ID registration
mode is completed. The power indicator of the All-in-
One Headset will change from yellow to green.
Notes:
• If ID registration fails, a warning sounds "beep, beep,
beep, beep" and then you will hear a voice prompt say
"Failed". If registration fails, the ID is not registered and
the "POWER" indicator blinks red.
If this happens, turn off the power and try registering
again.
• All-in-one headset or Order Taker that can register in
one center module is up to 32.
If you register IDs exceeding 32, the unused ID that has
been registered is automatically deleted in chronological
order.
• When registering the IDs of two or more All-in-one
Headset or Order Taker, register each headset or Order
Taker in order.
POWER
SERVICE
USE ONLY
Holding down
simultaneously.
Hold down the Power Button
to turn on.
d
Hold down the ID Registration Button
for 2 seconds or more.
Press the Power ON/OFF Switch to turn on.