Filter
Top Products
26
■ Installed System Setting
After the completion of installation work, system setup shall be made according to the equipment to be connected and the oper-
ation mode.
Setup operation for the installed system shall be carried out by the use of the PREV/NEXT button and the SEL button.
1. Turn on the power supply of the center module.
2. Press the [NEXT] button or the [PREV] button.
Indicator of the selected setup item blinks. Each time the
[SEL] button is pressed, there is a reciprocal
changeover between ON Select and OFF Select status.
The ON/OFF status can be defined by the style of indi-
cator blinking.
Setup item
AUX SP AUX IN
ON (Green)
AUX IN audio is output to the auxiliary speakers. No output
TALK TALK audio is output to the auxiliary speakers.
* The sound of Outside Mic is also output to AUX SP.
No output
PAGE PAGE audio is output to the auxiliary speakers. No output
BEEP BEEP audio is output to the auxiliary speakers. No output
OFF
OFF: Lighting time is short and unlighting time is long.
ON: Lighting time is long and unlighting time is short.
3. When the ON/OFF is changed over, the selected status
is reflected on the system in real-time.
4. When the [NEXT] button is pressed, the next setup item
is selected. (The setup item being selected is moved by
one to the lower position or to the top right.)
When the [PREV] button is pressed, the previous setup
item is selected. (The setup item being selected is
moved by one to the upper position or to the bottom
left.)
5. If any [NEXT], [SEL], or [PREV] button is not pressed for
10 seconds, blinking of the indicator is finished.
INSTALL SYSTEM SETTING
PREV
ECHO CANCELLER
DNR LEVEL
DUAL LANE
LANE SELECT
POS REMOTE
TX POWER
RED MAX
YELLOW MD
GREEN LOW
OFF OFF
SEL
AUX
SP
AUX IN
TALK
PAGE
BEEP
NEXT
Indicator of the selected setup item blinks.
NEXT button
SEL button
PREV button
Lit
Lit
Unlit
Unlit
OFF:
ON:
● Setup operation for AUX SP (Auxiliary Speaker)
The sound output is set up for the AUX SP.