Filter
Top Products
1752 and 1754 SHDSL Router User’s Guide
Edit IPSec Config
If to create a IPSec, the procedure is shown as follows:
Step 1: Create a new IPSec selector
Click on the Create a new selector link. The IPSec Selector page is displayed as follows:
Input the values on the fields respectively. The following table gives the range of values for
each option, which can be specified with this command and a default value.
Option Description
Ipversion
IPv4 only currently
Source IP Type Name of the selector
Start Source Address Start source address
End Source Address
End source address type
Destination IP Type
Destination address type
Start Destination
Address
Start Destination Address
Protocol
This option allows you to specify a protocol number
(protnum) value. The value 255 is interpreted as a
wild card entry.
Source Port
Source TCP/UDP port
Destination Port
Destination TCP/UDP port
78 June 2005 1752-A2-GB20-00