Filter
Top Products
1752 and 1754 SHDSL Router User’s Guide
Step 2: Create IPSec Interface
Click on the Create IPSec Interface link, the IPSec Interface page is displayed as follows:
Input the values on the fields respectively. The following table gives the range of values for
each option, which can be specified with this command and a default value.
field Description
interface name Name of the interface
ikeport The IKE port value; the UDP port number on
which IKE daemon listens on all valid unicast IPv4
and IPv6 addresses of this interface. The default
value is 500.
Status The status of IPsec on this interface. The default
value is disabled.
Note: if to create a IPSec Interface successfully, a new WAN service should be created in
advance via WAN connection page.
Step 3: Create IPSec Policy
If step1 and step 2 are successfully created, the Create IPSec Interface link will appear. Click
on the link, and then the IPSec Interface page is displayed as follows:
Input the values on the fields respectively. The following table gives the range of values for
each option, which can be specified with this command and a default value.
1752-A2-GB20-00 June 2005 79