Filter
Top Products
Operation
3-26
3160-A2-GB21-80
March 1999
12. Press F2 (Read) or F3 (R/W).
F1
Access 1:
Next Read R/W
F2
F3
The Read selection allows read-only access (SNMP “Get”) to the accessible
objects in the MIB when community name 1 is used. The R/W selection
allows Read/Write access (SNMP “Get” and “Set”) to the objects in the MIB.
Write access is allowed for all objects specified as read/write in the MIB.
Read access is allowed for all objects specified as read-only or read/write.
Configuring SNMP Traps
A trap is an unsolicited message that is sent from the DSU/CSU to an SNMP
manager when the DSU/CSU detects certain pre-specified conditions. These
traps enable the SNMP manager to monitor the state of the network.
The SNMP Trap configuration option must be enabled for trap messages to be
sent over the communications link. You must specify the number of SNMP
managers that are to receive traps from this DSU/CSU, an IP address for each
SNMP manager specified, and the type of traps to be sent from this DSU/CSU.
For more information, refer to Appendix C,
Configuration Options
,
and
SNMP
Traps
in Chapter 4,
Maintenance
.
Enabling SNMP Trap Messages
"
Procedure
To enable SNMP trap messages from this DSU/CSU:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
key until the Alarm selection appears on
the screen.
5. Select Alarm.
F1
Edit:
User Alarm Mgmt
F2
F3
6. Press F1 (Next) until the SNMP Trap configuration option appears.