Paradyne Hotwire M/SDSL and HDSL2 Termination Units Network Hardware User Manual


 
Configuration Options
A-25
8700-A2-GB20-00
April 2000
Table A-11. Telnet Session Options
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies if the unit will respond to a Telnet session request from a Telnet client on an
interconnected IP network.
Enable Allows Telnet sessions between the unit and a Telnet client.
Disable No Telnet sessions allowed.
Telnet Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether a user ID and password are required to access to the ATI through a
Telnet session. Login IDs are created with a password and access level. Refer to
Creating a Login in Chapter 6, Security.
Enable Security is enabled. When access is attempted via Telnet, the user is
prompted for a Login ID and password.
Disable No Login required for a Telnet session.
Session Access Level
Possible Settings: Administrator, Operator
Default Setting: Administrator
The Telnet session access level is interrelated with the access level of the Login ID.
Refer to ATI Access Levels in Chapter 6, Security, for more information.
Administrator This is the higher access level, permitting full control of the 87xx
Termination Unit. Access level is determined by the Login ID. If Telnet Login Required is
disabled, the session access level is Administrator.
Operator This is the lower access level, permitting read-only access to status and
configuration screens.
Inactivity Timeout
Possible Settings: Enable, Disable
Default Setting: Disable
Provides automatic logoff of a Telnet session.
H Inactivity Timeout is forced to Enable if the unit is in a DSLAM running in IP
conservative mode.
Enable The Telnet session terminates automatically after the Disconnect Time.
Disable A Telnet session will not be closed due to inactivity.
Disconnect Time (Minutes)
Possible Settings: 160
Default Setting: 5
Number of minutes of inactivity before a Telnet session terminates automatically.
Timeout is based on no keyboard activity.
H Disconnect Time (minutes) option appears when Inactivity Timeout is enabled.
1 to 60 The Telnet session is closed after the selected number of minutes.