Filter
Top Products
Standards Compliance for SNMP Traps
B-7
8700-A2-GB20-00
April 2000
The tests that affect the enterpriseTestStart and enterpriseTestStop traps and the
variable bindings depend on the interface. The specific tests and variable
bindings are described in the following table:
Interface
enterpriseTestStart/Stop
variable bindings
Possible Cause
DSL Network H ifIndex (RFC 1573)
H ifAdminStatus (RFC 1573)
H ifOperStatus (RFC 1573)
H ifType (RFC 1573)
H ifTestType (RFC 1573)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopLLB(4) – Initiates a
Local Loopback.
– testSendMon511(6) – Initiates a
Send and Monitor 511 test.
– testSendLLBUp(7) – Initiates an
LLB Up message to the remote
unit.
– testSendLLBDown(8) – Initiates
an LLB Down message to the
remote unit.
H enterpriseTest Start – Any
one of the following tests is
active on the interface:
– Line Loopback
– Remote Line Loopback
– Send and Monitor 511
H enterpriseTest Stop – No tests
currently running on the
interface.
DSX-1 or
G.703
H ifIndex (RFC 1573)
H ifAdminStatus (RFC 1573)
H ifOperStatus (RFC 1573)
H ifType (RFC 1573)
H ifTestType (RFC 1573)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopDTLB(3) – Initiates a
DTE Loopback.
– testLoopPLB(1) – A
Telco-initiated Payload
Loopback is active on the
interface (DSX-1 only).
– testLoopRLB(5) – Initiates a
Remote Loopback.
H enterpriseTest Start – Any
one of the following tests is
active on the interface:
– DTE Loopback
– Repeater Loopback
– Telco Payload Loopback
(DSX-1 only)
H enterpriseTest Stop – No tests
currently running on the
interface.