Filter
Top Products
Testing
5-4
7975-A2-GB20-40
December 1998
Repeater Loopback
Repeater Loopback (RLB) loops the signal being sent from the data port back to
the data port and to the network interface.
98-15932
NTU/LTU
Network
Interface
Port
Interface
Framer
EIA-530
Port
CAP
" Procedure
To run a Repeater Loopback:
1. Position the cursor at the Start command next to Repeater Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
Repeater Loopback cannot be started when a Line Loopback, DCLB, Remote
DCLB, or Data Terminal Loopback (DTLB) is active.
NOTE:
If a disconnected DSL loop is connected while a Repeater Loopback is
active, the connected units will not be able to synchronize.