Filter
Top Products
DSLAM Connections with remote CPE units 73
Model 3086 G.SHDSL Integrated Access Device User Guide 4 • Basic Application Configurations
–Cost:1
–Interface:[blank]
5. Go to G.SHDSL in the Configuration Menu, then the submenu Status. The Modem State should be “deacti-
vated.” (If not, go to the Action and change it to deactivate.)
Then in the Action submenu under G.SHDSL, change Action to Start, then click on Action.
DSLAM Connections with remote CPE units
Bridged application configurations to a DSLAM
Three bridged services are offered, RFC 1483 Bridged, PPPoA Bridged, and HDLC Bridged.
The configurations show a desktop on one end and a laptop on the other. The laptop and its Model 3086
would be replaced with a DSLAM.
RFC 1483 Bridged Configuration.
No additional IP addresses are needed other than the IP address chosen earlier. In fact, if you are configuring and
managing the model 3086 only from the CLI (Command Line Interface), an IP address is not needed at all. The
limitation of no IP address precludes the user from doing web management of the 3086 since management is
done via the Ethernet port.
As in the PPPoA Bridged application, both sides of the RFC 1483 bridged connection are on the same subnet.