Filter
Top Products
23
• dsl help: Lists all the commands that start with dsl that the
console recognizes.
• dsl set help: Lists all the commands that start with dsl set that the
console recognizes.
• dsl show help: Lists all the commands that start with dsl show that
the console recognizes.
• dsl show errcntr help: Lists all the commands that start with dsl
show errcntr that the console recognizes.
System Configuration Commands
The following commands allow the user to configure the system:
• system set password <password>: Sets the system password.
• system set circuitid <circuitid>: Sets the circuit ID.
• system set clockmode <internal|external|receiverecover>: Sets
the clock mode. Internal clock mode means the 3088RC provides the
clock to both the DSL and the serial interface. External clock mode
means the 3088RC uses the serial transmit clock as its DSL transmit
clock. Receive recover clock mode means that the 3088RC uses the
DSL receive clock as its DSL transmit clock and as the serial receive
clock.
Note X.21 External Clock Mode—The X.21 interface expects the
DCE to provide the clock used for both transmitting data and for
sampling receive data. When the 3088RC/D/V is set as a DCE,
it may be used in internal or receive recover clock modes. The
DSL generates a clock that is provided to the X.21 interface.
When the 3088RC/D/V is a DTE, it may be used in external
clock mode. The X.21 interface needs to provide the clock. This
clock is used by the DSL to sample the serial data and also to
update the receive data.
The 3088RC is set for either DCE or DTE by flipping the daugh-
ter-card. The 3088RC is a DCE if DCE points toward the front of
the 3088RC.
• system set dteif <normal|e1>: Set to E1 if the rear card is Model
3088RC/K/K. Set to normal for all other models.
• system set fpsw <enabled|disabled>: Enable or disable initiating
test modes using the front panel switches.