39
Connecting the Interface Driver Board
This package contains an interface driver board that allows you to config-
ure your front function card for ethernet operation. Figure 12 shows the
Interface Driver Board connected to a Model 3088RC front function card.
Figure 12. Driver Board mounted on Model 3088RC
Follow the instructions below to connect the interface driver board to the
front function card:
1. With the function card pulled out of the NetLink rack or clusterbox
chassis, locate the driver board to be replaced on the top of the
base unit front card.
2. Lift the old interface board gently off of the printed circuit board.
3. Position the 3088RC/C/AI-100B driver board on top of the function
card’s pc board with the sockets oriented toward the male pins.
Please be sure the label marked FRONT is pointed toward the front
of the function card (toward the LEDs).
4. Push the Interface Driver Board gently onto the socket and re-install
the function card into the rack or cluster system.