Filter
Top Products
24
The following commands allow the user to view the current
system configuration:
• system show config: Shows the configuration of the entire system,
including DSL and serial/T1/E1 lines.
Any changes to the system configuration or the DSL configuration will be
lost on the next power cycle unless the changes are saved. The com-
mand system save config is used to save the changes.
System Status Commands
The following commands show system status:
• system show status: Shows the following system status information:
LEDs, DSL test mode, front panel switch settings, DSL link state, and
configuration mode.
DSL Configuration Commands
The following commands are used to configure the DSL:
• dsl set timeslots <1–72>: Sets the number of timeslots. The data rate
is calculated by the equation: data-rate = #timeslots x 64k.
• dsl set annex <a|b>: Set the annex.
• dsl set lineprobe <enabled|disabled>: Enable or disable line probe.
• dsl set link <enabled|disabled>: Enable or disable the DSL port.
When disabled, a DSL link cannot be established.
• dsl set loopback <off|lal|rdl>: Start or stop loopbacks.
• dsl set pattern <off|511|511e>: Start or stop PRBS generator and
BER meter.
• DSL Error Monitor
The DSL error monitor inspects intervals to see if they have met the error
threshold (maxint). If the error monitor finds a certain number (intcnt) of
intervals that meet or exceed the error threshold, it will restart the DSL
link. The error monitor will wait (startdelay) seconds after the DSL link
comes up before it begins monitoring errors. After the startup delay, it will
Startup Delay Interval 1 Interval 2 …
Interval
totint
?startdelay⇒ ?inttime
⇒
?inttime
⇒
?inttime
⇒
?inttime
⇒