Patton electronic 2635 Network Router User Manual


 
15
Models 2603, 2621, and 2635 Getting Started Guide
About this guide
General observations
Clean the case with a soft slightly moist anti-static cloth
Place the unit on a flat surface and ensure free air circulation
Avoid exposing the unit to direct sunlight and other heat sources
Protect the unit from moisture, vapors, and corrosive liquids
Factory default parameters
IPLink Series High Speed Routers have the following factory default parameters.
Ethernet IP address: 192.168.200.10/24
WAN Connection: PPP Bridged
Ethernet and serial connections
MDI (LAN connector)
Model 2621 (X.21)—DB-15 port (DTE)
Model 2635 (V.35)—DB-25 port (DCE, DTE when using special V.35 cable)
For AC powered units, ensure that the power cable used with the device
meets all applicable standards for the country in which it is to be installed,
and that it is connected to a wall outlet which has earth ground.
For units with an external power adapter, the adapter shall be a listed Lim-
ited Power Source.
Hazardous network voltages are present in WAN ports regardless of whether
power to the unit is ON or OFF. To avoid electric shock, use caution when near
WAN ports. When detaching the cables, detach the end away from the
device first.
This device contains no user serviceable parts. The equipment shall be
returned to Patton Electronics for repairs, or repaired by qualified
service personnel.
In accordance with the requirements of council directive 2002/
96/EC on Waste of Electrical and Electronic Equipment (WEEE),
ensure that at end-of-life you separate this product from other
waste and scrap and deliver to the WEEE collection system in
your country for recycling.
WARNING
WARNING
WARNING
WARNING