Patton electronic 2635 Network Router User Manual


 
IP Services 94
Models 2603, 2621, and 2635 Getting Started Guide 9 • IP Services
IP Services
Certain System Services can be enabled or disabled. They are DNS Relay, FTP, TFTP, SNMP, and the
WEB Server.
The importance of disabling any of these services is an issue of security. If you are not using a particular service,
it is best to disable it. By disabling it, the associated port is not active, which means it is not available to abuse
with the intent of unauthorized access.
Figure 67. System Services configuration web page
WEB Server
The System Service which must be wisely disabled is the WEB Server. After you disable the WEB Server from
the web page, you can no longer access the any of the IPLink’s web pages. The only way to enable it is through
the Command Line Interface (CLI).
CLI Configuration
After configuring a terminal emulator to access the IPLink’s serial port, there are two commands for the
enabling or disabling the WEB Server. The following command enables the WEB Server so you can access the
management web pages via a browser. Remember that by only doing this command, the change is saved only
in volatile memory. Be sure to execute the next command to save it in non-volatile memory.
webserver enable
system config save
The next command disables the WEB server.
webserver disable