Filter
Top Products
WAN Service Configuration 61
Models 2603, 2621, and 2635 Getting Started Guide 6 • WAN Services
Frame Relay bridged
This application shows configuration for two IPLink units in bridged mode. If using a third party router at the
Central site, review the router’s configuration for connection to a remote bridge.
Remote Site Configuration.
First configure the IP address of the Ethernet port (interface ip1) via the command line (CLI) for
192.168.200.2/24. The PC must be on the same subnet for configuring the IPLink via the web pages.
1. Bring up the web-page management system on your browser by entering the IP address of the IPLink.
2. On the Menu, go to Services Configuration, then to WAN. Delete the factory default WAN services already
defined.
3. Click on Create a new service in the main window, select “Frame Relay bridged” and click on Continue.
4. Enter the description for the circuit in the Description field. This is a mandatory field. Without a descrip-
tion you cannot create a WAN service.
5. Click on Create a new service in the main window, select Frame relay bridged and click on the
Configure
button. (See figure 35.)
Figure 35. Frame Relay bridged creation
6. Click along the following path: Services Configuration > WAN > ‘Edit...’ Then click on Edit ‘Frame Relay
Channel’. (See figure 36.) The configurable parameters are:
• DLCI: Consult with your service provider for the DLCI number required. LMI uses DLCI 0, but ANSI/
CCITT has also reserved 1–15. Best practice (per the recommendation) is to use only DLCIs 16–991 for
FR data PVCs, and DLCIs 0–15 for LMI PVCs.