Patton electronic 2635 Network Router User Manual


 
Hardware installation 35
Models 2603, 2621, and 2635 Getting Started Guide 3 • Initial Configuration
Figure 12. Power connector location on rear panel (Model 2603/T shown)
3. Verify that the AC power cord included with your IPLink router is compatible with local standards. If it is
not, refer to chapter 13, “Contacting Patton for assistance” on page 112 to find out how to replace it with
a compatible power cord.
4. Connect the male end of the power cord to an appropriate power outlet.
5. Verify that the green Power LED is lit (see figure 13).
6. Unplug the AC power cord from the IPLink Series router to power down the unit.
The IPLink router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
CAUTION