Filter
Top Products
Loading Supplies 2-3
Loading a Ribbon
To load a new ribbon:
1.
Open the side access cover.
2.
Raise the printhead latch wing and rotate counterclockwise one-half turn
to unlock the printhead. Raise the printhead to an upright position.
3.
Slide the ribbon roll onto the hub, making sure the ribbon roll is up
against the hub flange.
4. Feed the ribbon as shown.
5.
Lower the printhead, but do not close the latch.
6.
Rotate the J-hook counterclockwise to unlatch it while holding the ribbon
take-up hub.
Ribbon Rollers
Latch Wing
Ribbon
Take-up Hub
Ribbon Supply
Hub