Filter
Top Products
3-4 Setting Supply Options
3. Press L or R to see the other option. After you display the option you
want, press E. Press U twice to exit to the Main menu.
Print Position
This function adjusts where data prints vertically on the supply. Adjust the
print if it is too close to the top or bottom of the supply, or overtypes the
pre-printed area. One dot is 0.0033 inch.
♦ If the data is too close to the bottom, increase the number.
♦ If the data is too close to the top, decrease the number.
Changing this setting only affects new formats sent to
the printer.
To change the setting, from the Main Menu, select Setup, then Supply.
Then, follow these steps.
1.
Press L or R until you see
2.
Press E. You will see the current setting, for example:
SUPPLY
l Print Pos r
Enter print pos
[-99/99]: +0