Filter
Top Products
5-4 Operator’s Handbook
Cleaning the Pinch and Feed Rollers
To clean the pinch and feed rollers:
1. Turn off the printer and open the supply cover.
2. Remove the supplies. See “Removing Supplies” in Chapter 3 for
more information.
3. Turn the platen roller with your fingers while running a dry, lint-free
cloth across the pinch and feed rollers as they turn. Make sure the
rollers are clean all the way around. If necessary, use a cloth
dampened slightly with distilled water.
4. Reload the supplies after the printer dries.
Cleaning the Sensors
To clean the on-demand sensor:
1. Turn off the printer and open the supply cover.
2. Remove the supplies. See “Removing Supplies” in Chapter 3 for
more information.
3. Open the label deflector by
gently pressing down with
two fingers.
4. Clean the on-demand
sensor with a soft cloth
moistened with distilled
water.
5. Reload the supplies, close
the label deflector and
supply cover.
On-Demand
Sensor