Pelco EW5001 Network Card User Manual


 
C2681M (2/08) 23
10. Connect all cables (refer to Figure 17):
NOTE: Be sure to fully seat each connector. Otherwise, environmental protection may fail, causing the unit to fail.
Figure 17. Connecting Cables to the EW5001
a. If installing a power cable: Connect the power cable connector.
(1) Remove the protective cover from the power connector on the rear panel.
(2) Connect the power cable to the power connector on the rear panel. The connector is keyed and only attaches one way. Make
sure you twist the connector all the way down.
b. Connect the weatherproof network connector.
NOTE: The supplied weatherproof network connector must be installed before you continue. To install the connector, refer to the
appropriate section: Separate Power and Network Cables on page 13 or Power-over-Ethernet (PoE) on page 16.
(1) Remove the protective cover from the network connector on the rear panel.
(2) Connect the weatherproof network connector to the network connector on the rear panel. The connector is keyed and only
attaches one way. Make sure you twist the connector all the way down.
c. If using an integrated antenna: Check the antenna connector to make sure it is fully seated. When inserting the connector, you should
hear or feel two clicks.
d. If using a separate antenna: Connect the antenna cable.
(1) Make sure the frequency of the antenna matches the frequency of the EW5001. A label is attached to the antenna connector;
the blue label is for 2.4 GHz, the red label is for 5.8 GHz.
(2) Make sure the antenna cable is the correct length (refer to Optional Accessories on page 5).
(3) Remove the protective cover from the antenna connector on the rear panel.
(4) Connect one end of the antenna cable to the antenna. Connect the other end of the cable to the connector on the rear panel.
Make sure both connectors are fully seated. When inserting the connector, you should hear or feel two clicks.
11. Close and latch the EW5001 to the J-box.
POWER CABLE
(SUPPLIED)
WEATHERPROOF NETWORK
CABLE (NOT SUPPLIED)
WEATHERPROOF NETWORK
CONNECTOR (SUPPLIED)